
6
Low-Chlorine Recipe
Ingredients:
• FreshWater
AG+
• Non-chlorine oxidizer (MPS
2
)
3
• Hot Spring MPS Test Strips
4
, or equivalent (MPS
2
, pH, total alkalinity)
• pH, hardness and total alkalinity adjusting chemicals
• Dichlor
1
, EPA registered source
When: What to do:
Every day
Run spa according to recommendations supplied to you by
the manufacturer of your spa.
Before Test the water with the Hot Spring MPS Test Strip (or equivalent).
each use If the MPS
2
level is low, add 1 tablespoon of MPS
2
to spa
per 250 gallons (approx. 1000 liters).
(Note: 1 tablespoon is approximately 1/2 ounce or 16 grams)
Use the Hot Spring MPS Test Strip (or equivalent) to test
the spa water after each addition of MPS.
2
If the test strip indicates levels below the OK range, add
1 tablespoon MPS
2
to spa per 250 gallons and re-test.
Enter spa only after test strip indicates a sufficient level
of MPS
2
.
After Add 1 tablespoon of MPS
2
to spa per 250 gallons
each use (approx. 1000 liters).
Once Adjust the pH, total alkalinity, and hardness as needed.
per week A convenient way to test pH and total alkalinity is the
Hot Spring MPS Test Strip.
Every 4 Drain and refill your spa. Replace FreshWater
AG+
and
months repeat sanitizer start-up.
As needed Shock treat with 1.5 tablespoons of an EPA registered
source of dichlor
1
per 250 gallons (approx. 1000 liters) to
remedy problems which may occur when bathing loads are
high, when successive MPS
2
test strip reading indicate
high demand, when water appears hazy or dull, when
unpleasant odors or eye irritation occur, after heavy wind
and rainstorms or if foam develops.
Recipe
There is one recipe for maintaining clean, clear, sanitized water with
minimum time and effort.
This recipe provides the easiest and most economical way to care for
your FreshWater
AG+
.
Komentáře k této Příručce